Faulty BM3 Flex fuel kit?

[SWFL_M3]

I also am having this issue. Carry Jordan has taken point talking with PTF trying to find a solution. I have re-flashed with updates and my car still will stall out randomly at red lights and such. Really starting to get annoying.

[stoes]

What setting is your hpfp on? It must be set at "original " under configuration tab in your map. I had the same problem. This fixed it.

[TR930]

Originally Posted by stoes

What setting is your hpfp on? It must be set at "original " under configuration tab in your map. I had the same problem. This fixed it.

Any updates on this?

[ironviet]

Originally Posted by stoes

What setting is your hpfp on? It must be set at "original " under configuration tab in your map. I had the same problem. This fixed it.

I did this same thing and it seemed to eliminate any idle issues at any mixture. I just can't explain what it does but it worked.

[tanzm4_]

I had an issue where when I first plugged everything in it read 0% E. Then I swapped the connections at the module by the seat back and everything was good to go.

[stoes]

Originally Posted by tanzm4_

I had an issue where when I first plugged everything in it read 0% E. Then I swapped the connections at the module by the seat back and everything was good to go.

What do you mean by swapped? I've also had to plug and unplug basically reset that module due to communication faults . The plugs are very cheap, there's no audible sound that clicks and I can't even feel when the clip secures , holding the plug in place. Turns out one of my plugs wasn't connected all the way because of this and believe me I thought it was connected. You have to press very hard and the visibility is bad, so you can't really tell when it's plugged in and secure if your not very familiar with it. I pressed so hard I thought I may break it but was so mad I didn't care. Well, Thsts when it finally popped into place (no sound was made) I could just tell it went down further than before. Since then no commutation errors.