Turbo Transformer Boost Controller. Simple, Reliable & Fun!

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[Joy15779]

Hi there! I m yr italia customer. I did the kratos stage 3 on my s55 with HCP. Does it work adding EXTRA PSI? I'm targeting 30 psi. Running 28 at today

[mike@x-ph.com]

Originally Posted by Joy15779

Hi there! I m yr italia customer. I did the kratos stage 3 on my s55 with HCP. Does it work adding EXTRA PSI? I'm targeting 30 psi. Running 28 at today

Hi,
Yes, you can use it to add a few PSI

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[Joy15779]

Originally Posted by mike@x-ph.com

Hi,
Yes, you can use it to add a few PSI

Dear Mike,

Hope you're doing well.

I purchased it and installed and set properly.
At very beginning I was enthusiast cause at low rpm (psi) was working very well.
I shouted for happiness but unfortunately it stops quite immediately because while pressing the gas and increasing rpm (psi) the engine started ... like knocking.... the lower PSI set on the T-T the better, if you put 4 psi increase, it works VERY good at low rpm but gives error immediately, if you set 1 psi increase it works less but for higher rpm.
Finally I must remove it most probably because my map is already strong (Halim Stage 3, waiting him for the 4).
This device cannot works on heavy tuned map, this is bottom line.

I was trying also to run it at opposite, working ONLY at low rpms (psi) and stop it function above certain rpm (psi) where the map is strong itself but I didn't succeed cause the APP doesn't permit this function.

Very sorry because it's a good device.

Thanks and kind regards,
Giorgio

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]

[mike@x-ph.com]