700hp m3 f80 competion on Pure turbos

[TTR]

Originally Posted by domino_z

Don't Dodson offer upgraded clutch packs for this car? Their entry level superstock should suffice at that power and will drive as close to stock as you'll get

I've built 2 dual clutch boxes to different levels, r35 GTR and evo x, with Dodson parts and both times ssp was always the second best option in those platforms

Ssp use lintex clutch discs from China vs Dodson sourcing theirs from exedy in Japan

I thout Dodson is worse than SSP, didnt known about their parts

[TTR]

[StahlMeister]

Originally Posted by Saschi

i only have

- JB4 on MAP7 (with 102 Aral Ultimate Fuel)
- VFRS DP
- BMS Intake
- Lightweight Exhaust

And with stock Tires i think its very slippery?!
and i am wondering you have no Problems with the Clutch?

with my Setup i had 100-200km/h in 6,9sec. on logic Driftbox !?

Did you have any issues with clutch slip running this setup?

Did you dyno the setup?

[TTR]

https://instagram.com/ttrandrey/

[TTR]

Some new photos

[PeterPure]

looking good!

[Lojs]

The asymmetric discoloration of the titanium on your acra does not look right to me.
As if the passenger side exhaust valve would not be opening or not fully opening and the high rev hot gasses would not bypass the muffler.
You might still be "hearing" valves working as the driver side opens.

[domino_z]

Originally Posted by TTR

I thout Dodson is worse than SSP, didnt known about their parts

Check this thread and see what the reputable shops are using on their builds

https://f80.bimmerpost.com/forums/sh....php?t=1384960

Did you end up swapping out the clutch pack yet?

[TTR]

Originally Posted by Lojs

The asymmetric discoloration of the titanium on your acra does not look right to me.
As if the passenger side exhaust valve would not be opening or not fully opening and the high rev hot gasses would not bypass the muffler.
You might still be "hearing" valves working as the driver side opens.

99% time i drive car in sport plus mode with open valves, i will check valves but they are working fine, if 1 valve was not open/close - i def feel it

[TTR]

Originally Posted by domino_z

Check this thread and see what the reputable shops are using on their builds

https://f80.bimmerpost.com/forums/sh....php?t=1384960

Did you end up swapping out the clutch pack yet?

No, i still use a stock clutch, now try to find a best solution (ssp or dodson), install it, add meth and go to 2.2 bar boost (now is 1.8)

Goal is like 750 whp and 100-200 ~5.2